CSPOLA600 - Software Update V1.0.0.1
Make sure you have a USB 3.0 THUMB DRIVE.
Make sure to use software V1.0.0.1 to update the CSPOLA,
to be used with Vision R 800 V1.2.0.1
1. Use the
power switch to turn off the unit.
2. Proceed to download file V1.0.0.1.zip and then place it in the root of the USB THUMB DRIVE.
Do not forget to unzip the file.
3. Plug the USB THUMB DRIVE in the indicated port.
4. Use the
power switch to turn on the unit.
Below is the booting and updating screen sequence.
|
Splash Logo
|
Loading system
|
Update in process
|
Update completed
|
Unit is Off |
|
4.1 Let the unit turn on.
|
4.2 Unit is reading files
|
4.3 Unit is updating the software
|
4.4 Unit completed the update. You can turn
off the unit.
Use the power switch.
|
4.5 Remove the USB THUMB DRIVE
|
|
|
|
|
|
|
6. Use the
power switch to turn on the unit.
7. Connect the remote control into the screen unit CSPOLA600.
Use the USB cable to recharge the remote control
8. Align the remote control with the CSPOLA600 screen.
9. On the remote control press and hold
ENG MODE screen if followed on the remote control and CONFIGURATION on the CSPOLA600
10. Verify the software version is
Velvet V.1.0.0.1
Related Articles
CSPOLA600 - Why the screen display white?
Make sure you have a USB 3.0 THUMB DRIVE. Make sure to use software V1.0.0.1 to update the CSPOLA, to be used with Vision R 800 V1.2.0.1 1. Use the power switch to turn off the unit. 2. Proceed to download file V1.0.0.1.zip and then place it in the ...VISIONC600 - No possible to export charts
An error message is displayed at the end of the update of the Vision-C 600 Message here is the one when connected in IP* Check that the software version to install is higher one than the one already installed on the Vision C 600: click on te arrow in ...CSPOLA600 - Changing BIOS
Make sure you have a USB or wireless keyboard 1. Use the power switch to turn off the unit. 2. Prepare a keyboard or wireless keyboard and connect it to the USB port [Recharging S/W Update] 3. Press and hold the key on the keyboard, then turn on the ...VISIONC600 - Configuration via IR
Cables Connections It is mandatory to update the screen to allow the communication between Vision-R800/700 and Vision-C 600. Settings Configuration & Calibration 1. Connect the memory unit USB in any of the indicated USB ports. Refer to the image ...VISIONC600 - Configuration via network
Cables Connection It is mandatory to update the screen to allow the communication between Vision-R800/700 and Vision-C 600. Settings Configuration & Calibration 1. Go to settings 2. Insert your tech code. 3. Navigate to Ruler and select distances Set ...