VISIONC600 - No possible to export charts

An error message is displayed at the end of the update of the Vision-C 600

Message here is the one when connected in IP*

Check that the software version to install is higher one than the one already installed on the

Vision C 600: click on te arrow in the middle of the screen and the versions will be displayed :

> On the left, the new version to install.

> On the right, the actual version of the screen.

The issue is the same if the update is done via the USB stick.

Check in the <Devices> screen of the Vision-R 800 that the software version of the

Vision C 600 is lower (or identical) than the one of the Vision-R-800 (Here they are

the same ones).

Update the Vision R 800 with a identical or higher version than the one of the Vision C 600

and update the screen.

• Related Articles

• CS550 - Product does not turn on

  Possible Causes Power cable not plugged in No light on power supply Suggested Solutions Unplug and replug the power cable to ensure proper fit. Change power supply

• CSPOLA600 - Don’t want the slideshow during sleep mode

  Possible Causes Needs to be turned off Suggested Solutions In system setup, change the “Slideshow” to “OFF”. Refer to user manual for instructions.

• CS550 - Don’t want the slideshow during sleep mode

  Possible Causes Needs to be turned off Suggested Solutions In system setup, change the “Slideshow” to “OFF”. Refer to user manual for instructions.

• CSPOLA600 - Product will not respond to remote control

  Possible Causes IR detector is dirty. Batteries in remote are dead Suggested Solutions Clean the IR detector. Recharge the remote control using the USB cable. Replace the battery

• CSPOLA600 - Product does not turn on

  Possible Causes Power cable not plugged in No light on power supply Suggested Solutions Unplug and replug the power cable to ensure proper fit. Change power supply