CSPOLA600 - Why is the screen black?

1) Check if the power source is working. Voltage output 12V.

2) Check if the black screen appears after turning on the power.

3) It is possible that the PN CSP622 Converter board needs to be replaced

• Related Articles

• CSPOLA600 - Why the screen display white?

  Make sure you have a USB 3.0 THUMB DRIVE. Make sure to use software V1.0.0.1 to update the CSPOLA, to be used with Vision R 800 V1.2.0.1 1. Use the power switch to turn off the unit. 2. Proceed to download file V1.0.0.1.zip and then place it in the ...

• VISIONC600 - VisionR700 & VisionR800 keyboard can't control the screen.

  This problem can only occur if the screen VISIONC600 is configured with the VisionR using network method. When the screen VISIONC600 is not available the chart library is disabled. The letter (S) is not showing. Possible reasons 1. Screen VISIONC600 ...

• CSPOLA600 - Software Update V1.0.0.1

  Make sure you have a USB 3.0 THUMB DRIVE. Make sure to use software V1.0.0.1 to update the CSPOLA, to be used with Vision R 800 V1.2.0.1 1. Use the power switch to turn off the unit. 2. Proceed to download file V1.0.0.1.zip and then place it in the ...

• CSPOLA600 - Letters appear to be wrong size

  Possible Causes Chart Screen not calibrated Suggested Solutions Refer to user manual to adjust calibration distance. Min. dist. 5 ft. ~ Max. dist. 19.5 ft Remarks: Distances less than 10 ft may cause issues with accommodation.

• CSPOLA600 - Not booting up

  The screen is not supposed to display the boot screen below: However, it often happens when you power off at boot, or when you power off without using the power button. It is a normal screen caused by when the operating system is not found at boot. ...