CS550 - Product will not respond to remote control

CS550 - Product will not respond to remote control

Possible Causes

  1. IR detector is dirty.
  2. Batteries in remote are dead

Suggested Solutions

  1. Clean the IR detector.
  2. Recharge the remote control using the USB cable.
  3. Replace the battery

    • Related Articles

    • CSPOLA600 - Product will not respond to remote control

      Possible Causes IR detector is dirty. Batteries in remote are dead Suggested Solutions Clean the IR detector. Recharge the remote control using the USB cable. Replace the battery

    • CS550 - Product does not turn on

      Possible Causes Power cable not plugged in No light on power supply Suggested Solutions Unplug and replug the power cable to ensure proper fit. Change power supply

    • CSPOLA600 - Product does not turn on

      Possible Causes Power cable not plugged in No light on power supply Suggested Solutions Unplug and replug the power cable to ensure proper fit. Change power supply

    • VISIONC600 - VisionR700 & VisionR800 keyboard can't control the screen.

      This problem can only occur if the screen VISIONC600 is configured with the VisionR using network method. When the screen VISIONC600 is not available the chart library is disabled. The letter (S) is not showing. Possible reasons 1. Screen VISIONC600 ...

    • CSPOLA600 - Configuration with APH550

      1. Hold the central button down while pressing the “ON/OFF” button. The monitor comes on. 2. When you hear the beep, remove your finger. The following screen will appears. 3. Go to the tab “Chart”. 4. “BF” corresponds to acuity notation in feet 5. ...