ISSUE | CAUSE | SOLUTION |
No illumination | The cable isn't connected correctly with the power socket | Connect the power cable correctly |
The main power switch is on "O" position | Place the switch on "I" position | |
The plug on the power box is loosen | Insert the plug firmly | |
The plug on the lamp cap is loosen | ||
The bulb has burnt out | Change the bulb | |
The fuse has blown | Change the fuse | |
The bulb is not assembled properly | Assemble the bulb properly | |
The filter lever is in the middle position or in the position of gray filter | Set the filter lever to the correct position | |
The brightness adjustment knob is at minimum | Set the brightness adjustment knob | |
Slit is too dark | Voltage selector is wrongly set | Set the voltage selector correctly |
The coat of the reflecting mirror is oxidized Too much dust on the reflecting surface | Change the reflecting mirror Clean the surface with the brush | |
Fuse has blown | Voltage selector is wrongly set | Set the voltage selector properly |
The fuse doesn't comply with the specification | Replace it with a suitable fuse | |
Slit width closes automatically | The slit width control knob is too loose | Adjust the tightness of the control knob |
Fixation bulb is off | The output plug is loose | Insert the output plug firmly |