E-Tess TOUCH SCREEN CALIBRATION

E-Tess TOUCH SCREEN CALIBRATION

In case of unresponsiveness or unprecise touch commands, is recommended to calibrate the touch screen following the steps below:

1. At the upper bar, press the setup button to access the configuration/maintenance menu. 


2. Select the "Touch screen calibration" function .

3. Four crosses will successively appear at the four corners of the screen. Click at the centre of each
cross when they appear on screen.
Once this operation has been carried out, you get back to the general configuration menu.






    • Related Articles

    • PRO-E USER MANUAL

    • Table cutout scheme - Pro-E and Mr. Series

      Cutout scheme to prepare the workbench for the Edgers M40 (Pro Series), M24 and M22 (Mr. Series)

    • Error Codes_B21-B41_L11-L12-L13-L14-L20_M22-M24-M25

      Opt 1 Please contact your technician with the product data. Opt 1000 Opt 1001 Internal error. Please contact your support technician.+48 Opt 1002 Unforeseen error. Please contact your support technician. Opt 1003 No internal memory. Please contact ...

    • Adjust the shape axis position

      Principle This adjustment allows you to set the shape axis position in relation to the 22mm or 18-14mm posiblock Reminders Shape axis position adjustment condition •After wheel calibration, If the shapes are cut off-axis. For each material, carry out ...

    • How to carry out the autotests on Essilor edgers

      To test the proper performance of the edger, select from home screen. 1. Edger autotests 2. Initialisation and rotation of lens shafts 3. Reproducer: lens shaft raising and lowering 4. Right feeler movement 5. Left feeler movement 6. Closing of lens ...