How to carry out the autotests on Essilor edgers

How to carry out the autotests on Essilor edgers

To test the proper performance of the edger, select  from home screen.





1. Edger autotests
2. Initialisation and rotation of lens shafts
3. Reproducer: lens shaft raising and lowering
4. Right feeler movement
5. Left feeler movement
6. Closing of lens shafts
7. Wheel rotation
8. Rotation of Grooving/Milling/Drilling (GMD) module
9. Movement of Grooving/Milling/Drilling (GMD) module
10. Transfer initialization
11. Door
12. Water test
            ◦ trough spraying
            ◦ door spraying
      1. Select the autotest to be carried out.
      2. Press  to start the test cycle.
            You can press  to stop the cycle at any moment.
            > The result is displayed on the right of the icon of the autotest carried out:
            ◦ The equipment is operational.
            ◦ A malfunction has been detected; a description is displayed in the message box on the right.









    • Related Articles

    • Table cutout scheme - Pro-E and Mr. Series

      Cutout scheme to prepare the workbench for the Edgers M40 (Pro Series), M24 and M22 (Mr. Series)

    • Adjust the shape axis position

      Principle This adjustment allows you to set the shape axis position in relation to the 22mm or 18-14mm posiblock Reminders Shape axis position adjustment condition •After wheel calibration, If the shapes are cut off-axis. For each material, carry out ...